Welcome Note

HELLO, WORLD !!!

 YOU HAVE ENTERED THE RIGHT PLACE.

 WELCOME TO CL3VERTRONICS !!!!!

 WELCOME













Brought to you with 💗 lack of 🛌 and lots of 🌙.

Comments

Post a Comment

Popular posts from this blog

MicroPython #4: Interfacing Sensors

Image
MicroPython Interfacing Sensors DHT-11 Sensor interphase with NodeMCU At the end of this, you will be able to interphase DHT11 Temperature Sensor with ESP 8266 NodeMCU bare-metal and also by attaching external LED's. The whole process will be done by MicroPython programming. So, Let's begin with !  Note:  You must have your MicroPython firmware pre-flashed onto your board before beginning with this. If not, follow up these  before getting back here. MicroPython #1: Introduction and Gearing U p MicroPython #3: PWM, LED Fade MicroPython #2: Triggering I/O's Introduction to DHT 11 and Sensor Interphase  The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin. Here, we'll operate it on Analog mode. There is a dht   module that comes with the MicroPython firmware by default. So,...
Read more

Taiyo Yuden BLE Kit - Review

Image
  Hi,  Recently, I got an opportunity to  #RoadTest  Taiyo Yuden Bluetooth® Low Energy KIT from  #Element14 . Here is the full RoadTest blog having insights on Getting started, Hardware/Software tools, Testing, Review, Opinions and building Projects with this BLE module. Overall, Taiyo Yuden BLE module is an excellent device based on  #nRF52811  SoC and having good integration with  #nRF52_SDK . Would highly recommend this for new designs and development. >> Main RaodTest Blog https://www.element14.com/community/roadTestReviews/3413/l/taiyo-yuden-bluetooth-le-evk-review >>  First and basic test by running a blinky application. Taiyo Yuden BLE EVK : Toggling GPIOs >> Gearing up by implementing a simple GPIO toggling application. Taiyo Yuden BLE EVK : Wireless LED Control >> Implemented custom sequence for controlling multiple GPIOs with UART interface. Taiyo Yuden BLE EVK : Miniature BLE Automation Thanks to  TAIYO...
Read more

MicroPython #2: Triggering I/O's

Image
MicroPython Triggering Input / Output Ports   At the end of this, you will be able to trigger High and Low voltages to your I/O ports and see it on inbuilt LED in Pin2 of ESP 8266 and also by attaching external LED's. The whole process will be done by MicroPython programming. So, Let's begin with !  Note : You must have your MicroPython firmware pre-flashed onto your board before begining with this. If not, follow up MicroPython #1: Introduction and Gearing Up   before getting back here. >>  Initial IDE Setup  >> Connect the board to your computer via USB cable (Check if it has data transfer too) Here, I am using ESP 8266 NodeMCU - V.3 board to run MicroPython. >> Open your Thonny IDE and do initial setup as follows: >> Go to Tools >> Options in the top window.  The above dialog box appears and in Interpreter window, select MicroPython (Generic) language for intrepreting. ...
Read more